Great, but had an incident...
I really like this clearomizer. I like the feel of it on my lips, it holds enough juice for a days worth, and the vapor production is good. One complaint I have though, is that on my ZMax mod, it screws down into it past where I can see the base. This was problematic when I screwed it down a bit too tight, and the bottom piece holding all the juice unscrewed and my juice went all over the place. I don't know if anyone else has had this problem, maybe it's because I'm new to this. You would think that they could make the threading for the base of the eVod reversed from the threading of the connector. It just doesn't make sense to me to have a possibility of spilling juice all over the place. Avoid my problem by not screwing this thing down all the way. Just screw it in until there's a slight bit of resistance and you're done. Also, when unscrewing, hold it upside down just in case so you don't lose your juice.
Another thing I run into is I get some splash from time to time. Which I never get from my Kanger. I don't know if it's from pulling in a bit too hard or what but it seems to always eventually happen.
Reviewed by: (Verified Buyer) J-WeB from Florida.